CGXJV - N3806 BLACK TY-II STENCIL INK

  • MSDS: CGXJV
  • Manufacturer: NILES CHEMICAL PAINT CO
  • Product Name: N3806 BLACK TY-II STENCIL INK
  • National Stock Number: 7510-00-161-0811
Product Identification

Product ID:N3806 BLACK TY-II STENCIL INK
MSDS Date:09/01/1989
FSC:7510
NIIN:00-161-0811
MSDS Number: CGXJV

Responsible Party
NILES CHEMICAL PAINT CO.
225 FORT STREET
NILES, MI 49120
US

Emergency Phone: 219-236-5856

Info Phone: 616-683-3377

Preparer: MICHEAL LICHATOWICH

Cage: 02388

Contractor
NILES CHEMICAL PAINT
307 NILES, MI 49120 US

Telephone: 616-683-3377/219-236-5856

Cage: 02388

Ingredients

TOLUENE (VP = 22 @ 20C)

CAS: 2037-26-5

Fraction By Weight: 36.0%

OSHA PEL 200 PPM

ACGIH TLV: 100 PPM/STEL 150


ALKYD RESIN

CAS: 63148-69-6

Fraction By Weight: 14.0%


XYLENE (SARA 313) (CERCLA) (VP = 7.0 @ 20C)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 7.0%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM/STEL 150

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


ACRYLIC RESIN

CAS: 29354-73-2

Fraction By Weight: 1.0%


BUTYL CELLOSOLVE (VP = 0.6 @ 20C)

CAS: 111-75-2

Fraction By Weight: 1.0%

OSHA PEL 50 PPM

ACGIH TLV: 25 PPM


COBALT COMPOUND (SARA 313)

CAS: 7440-48-4

RTECS: GF8750000

Fraction By Weight: 41.0%

OSHA PEL 0.1 MG/M3

ACGIH TLV: 2.0 MG/M3


PROPRIETARY INGREDIENT

Fraction By Weight: BALANCE


VOC = 4.65 LBS/GL

RTECS: 9999999VO

OSHA PEL NOT RELEVANT

ACGIH TLV: NOT RELEVANT

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE: IRRIT, LACRIMATION, REDNESS,
BLURRED VISION. SKIN: CAN BE ABSORBED IN TOXIC AMOUNTS. INHAL:
NASAL AND RESPIRATORY IRRIT, CNS DEPRESSION, NAUSEA, HEADACHE,
VERTIGO, UNCONSCIOUS, ASPHYXIATION. INGE ST: GI IRRIT, ABDOMINAL
PAIN, NAUSEA, VOMIT AND DIARRHEA.
Effects of Overexposure:CHRONIC: ANOREXIA, CORNEAL VACUOLIZATION,
INCOHERENCE, PHOTOPHOBIA.

First Aid

First Aid:EYE: FLUSH W/WATER FOR 15 MINUTES. SKIN: REMOVE CONTAM
CLOTHES, WASH BEFORE REUSE. WASH W/SOAP & WATER. INHAL: REMOVE TO
FRESH AIR. ARTIF RESP IF NEEDED. INGEST: CALL DR. IN ALL CASES, GET
MED AID.

Fire Fighting

Flash Point Method:TCC
Flash Point:40.0F,4.4C
Autoignition Temp:Autoignition Temp Text:NE
Lower Limits:0.8
Upper Limits:10.0
Extinguishing Media:DRY CHEMICALS, FOAM AND CO2.
Fire Fighting Procedures:USE POSITIVE PRESSURE MODE SCBA W/FULL-FACE
PIECE AND PROTECTIVE CLOTHES. USE WATER TO COOL CONTAINERS. KEEP
CONTAINERS TIGHTLY CLOSED.
Unusual Fire/Explosion Hazard:VAPORS >AIR & TRAVEL TO IGNITS. CLOSED
CONTAINERS EXPLODE IN HIGH HEAT. DURING EMERGENCY CONDITIONS,
OVEREXPOSURE TO DECOMP PRODUCTS MAY CAUSE A HEALTH HAZARD.

Accidental Release

Spill Release Procedures:ELIMINATE IGNITS. DIKE AND ABSORB W/INERT
MATERIAL (CLAY OR SOIL). SHOVEL RECLAIMED LIQUID & ABSORBENT INTO
RECOVERY OR SALVAGE DRUMS FOR DISPOSAL.

Handling

Handling and Storage Precautions:AVOID STORAGE AT HIGH TEMPS, NEAR FIRE
OR OPEN FLAME. KEEP CONTAINER CLOSED WHEN NOT IN USE. AVOID ROUGH
HANDLING.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTY. DO NOT WELD OR FLAME CUT ON EMPTY DRUMS.

Exposure Controls

Respiratory Protection:USE APPROPRIATE PROPERLY FITTED RESPIRATOR
DURING AND AFTER APPLICATION UNLESS AIR MONITORING DEMONSTRATES
VAPOR/MISTS LEVELS ARE BELOW LIMITS. FOLLOW RESPIRATOR MANUFACTURER
DIRECTIONS FOR USE.
Ventilation:VENT IN VOLUME & PATTERN BELOW EXPOSURE LIMITS.
Protective Gloves:CHEMICAL RESISTANT
Eye Protection:CHEM GOGGLES/SAFETY GLASSES/FACE SHIELD
Other Protective Equipment:CLOTHES AS NEEDED TO PREVENT SKIN CONTACT.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING OR USING
RESTROOMS.
Supplemental Safety and Health
NK

Chemical Properties

Boiling Pt:B.P. Text:231 TO 330F
Decomp Temp:Decomp Text:NE
Vapor Density:>AIR
Viscosity:90-100 KU
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID, ODOR OF SOLVENTS.
Percent Volatiles by Volume:84.11

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS AND CAUSTICS.
Stability Condition to Avoid:HIGH TEMPERATURES AND SHOCK FROM DROPPING.
Hazardous Decomposition Products:CAN PRODUCE CARBON MONOXIDE AND CARBON
DIOXIDE.

Disposal

Waste Disposal Methods:IN ACCORDANCE W/FEDERAL, STATE AND LOCAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.